Xantrex Technology MS2000 - Manual (Page 12)

Safety
x 975-0125-02-01
9. If it is necessary to remove a battery, always remove the grounded terminal
from the battery first. Make sure all accessories are off, so as not to cause an
arc.
10. Be sure area around battery is well ventilated.
11. Clean the battery terminals. Be careful to keep corrosion from coming in
contact with your eyes.
12. Study all battery manufacturer’s specific precautions such as removing or not
removing cell caps while charging and the recommended rates of charge.
13. For refillable (flooded) batteries, add distilled water in each cell until the
battery acid reaches the level specified by the battery manufacturer. This helps
to purge excessive gas from cells. Do not overfill. Carefully follow the
manufacturer’s recharging instructions.
FCC Information to the User
This equipment has been tested and found to comply with the limits for a Class B
digital device, pursuant to part 15 of the FCC Rules. These limits are designed to
provide reasonable protection against harmful interference when the equipment is
operated in a residential environment. This equipment generates, uses and can
radiate radio frequency energy and, if not installed and used in accordance with
the instruction guide, may cause harmful interference to radio communications.
However, there is no guarantee that interference will not occur in a particular
installation. If this equipment does cause harmful interference to radio or
television reception, which can be determined by turning the equipment off and
on, the user is encouraged to try to correct the interference by one or more of the
following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and the receiver.
• Connect the equipment into an outlet on a circuit different from that to which
the receiver is connected.
• Consult the dealer or an experienced radio/TV technician for help.