Figure 1-3, Front panel lights and buttons –8, L is shown in figure 1-3 – Xantrex Technology MS2000 User Manual
Page 26: D in table 1-2
Introduction
1–8
975-0125-02-01
Figure 1-3 Front Panel Lights and Buttons
Table 1-2 Description of Front Panel Lights and Buttons
Feature
Description
1
External AC light illuminates when you are connected to an AC source like the utility grid or a
generator and the AC is qualified.
2
Inverter ON light illuminates when the MS2000 is operating in invert mode.
3
Low Battery light illuminates when the battery voltage is low.
4
Network light illuminates when there is activity on the network.
5
Fault light illuminates if a fault condition occurs.
6
Charger ON light illuminates when the main charger is in charge mode and is producing DC output to
charge your batteries.
7
>75A light illuminates when the total charge current of the main charger and the Echo Charger is greater
than or equal to 75 amps DC.
8
25–75A light illuminates when the total
charge current of the main charger and the Echo Charger
is
greater than or equal to 25 amps DC and less than 75 amps DC.
9
10–25A light illuminates when the total
charge current of the main charger and the Echo Charger
is
greater than or equal to 10 amps DC and less than 25 amps DC.
10
<10A illuminates when the total
charge current of the main charger and the Echo Charger
is less than 10
amps DC.
11
Charger Enable button toggles between enable (On) and disable (Off). When the charger is enabled, it
can produce DC output to charge your batteries. When the charger is disabled, it does not produce DC
output to charge your batteries, but still passes AC input through to AC loads (if present).
12
Inverter Enable button toggles between enable (On) and disable (Off). When the inverter is enabled, it
can produce AC output to run your AC loads. When the inverter is disabled, it does not produce AC
output to run your loads; however, if qualified AC is present, the unit passes AC through to AC loads.
13
Reset button is used for several functions: to reset after a fault, to perform a power on reset, to wake the
MS2000 from Power Save mode or Hibernate mode. (See “System Modes” on page 2–6 for a
description of the different modes.) To perform a power on reset, hold the reset button for about 5
seconds. All front panel lights will illuminate to indicate the unit has reset.
2
3
4
5
6
7
9
10
13
11
12
1
8