Xantrex Technology MS2000 - Manual (Page 40)

Operation
2–10 975-0125-02-01
5. Press Enter.
You are now in Safe mode.
6. Press Exit twice to return to the System Home Screen.
To exit Safe mode and return to Operate mode:
1. On the System Settings menu, under Desired Mode, select “Operate.”
2. Press Enter.
Hibernate mode
Characteristics Hibernate mode removes network power from the System Control Panel and all
Xanbus-enabled devices on the Xanbus system. All operations are suspended
(including starting and stopping the generator) until power is restored to the
network. All Xanbus-enabled devices other than the MS2000 have no network
power.
When to use Use Hibernate mode when the Xanbus system is left unattended for long-periods
of time to prevent any unattended system activity and to prevent battery drain
during long periods of inactivity.
The system will automatically enter Hibernate mode if it is in Power Save mode
for more than two hours.
If there are active faults in the system, you cannot force the system into Hibernate
mode. Clear any active faults, correct the condition that caused the fault, then put
the system into Hibernate mode.
Restoring power Once in Hibernate mode, the System Control Panel cannot return the System to
Operate mode. You must restore power to the network by pressing the Reset
button on the MS2000 front panel for several seconds.
Figure 2-7 Safe Mode
Important: To prevent any unattended system activity, put the system into
Hibernate mode from the System Control Panel before putting your boat into
storage.