Xantrex Technology MS2000 - Manual (Page 30)

Introduction
1–12 975-0125-02-01
System Accessories and Network Components
System accessories can be used with the MS2000 in a Xanbus system. The
System Control Panel (SCP) provides configuration and monitoring capability for
Xanbus-enabled devices such as the MS2000. Automatic Generator Start (AGS)
automatically starts and stops your generator. It continuously monitors your
battery system and thermostats and starts the generator if the battery state of
charge or the voltage reaches preset limits, or the air conditioner or heater needs to
be run.
Table 1-5 provides the part numbers for the system accessories.
Consult with your local system designer to determine what network components
will be needed for your specific installation. Table 1-6 provides a list of network
components and part numbers. Pre-made cables are available in standard lengths
ranging from 3 feet to 75 feet.
These accessories and network components are available from any authorized
Xantrex dealer or at www.xantrex.com. Detailed information on planning and
installing your network is available in the Xanbus System Installation Guide. This
guide is available for downloading at www.xantrex.com
Table 1-5 System Accessories
Accessory Part number
System Control Panel (SCP) 809-0910
Automatic Generator Start (AGS) 809-0915
Table 1-6 Network Components and Part Numbers
Network Component Part Number
Network termination — Male (2 per pack) 809-0901
3-way network connector 809-0903
Network termination — Female (2 per pack) 809-0905
Network cable 3 ft. (0.9 m) 809-0935
Network cable 5 feet (1.5 m) 809-0936
Network cable 7 feet (2.0 m) 809-0937
Network cable 10 feet (3.0 m) 809-0938
Network cable 14 feet (4.3 m) 809-0939
Network cable 25 feet (7.6 m) 809-0940
Network cable 50 feet (15.2 m) 809-0941
Network cable 75 feet (22.9 m) 809-0942