3Com CommWorks 5210 - Manual (Page 105)

Configuration 105
Configuration The configuration command line interface (CLI) uses the following syntax:
tcmget command:
tcmget [-h] [-l logfile] [-c readcomm] [-C writecomm]
[-z] [-L] [-a] [-f file] [-F] [-G group
[ parameter]...]... target
tcmset command:
tcmset [-c readcomm] [-C writecomm] [-h] [-l logfile]
[-z] [-L] [-f filename] -G group parameter value
[parameter value]...target
The options and parameters for the tcmget and tcmset commands are
described below. Parameters are shown in parenthesis after the flag name as
appropriate.
-c (readcomm)
SNMP read community string.
-C (writecomm)
SNMP write community string.
-h
Displays this help message.
-l ( logfile)
Log file for system diagnostic messages. GUI default: log to UNIX syslog; CLI
default: stderr. Specify ’-’ (hyphen) to reverse these two behaviors.
-z
Disable set logging for this application.
-L
List all groups, or if -G is provided, list parameters for each group specified as
part of a -G argument.