3Com CommWorks 5210 - Manual (Page 24)

24 C HAPTER 1: I NSTALLATION
Integrating with HP
OpenView The IP Telephony Manager installation script installs OpenView integration files
to the appropriate OpenView Network Node Manager subdirectories.
OpenView integration occurs as part of the IP Telephony Manager installation,
when the OpenView environmental variables are set beforehand. To integrate
IP Telephony Manager with OpenView manually, follow the procedure below.
1 Set the OpenView environmental variables.
# cd /opt/OV/bin
# . ./ov.envvars.sh
2 Test the environmental variables.
# cd $OV_BIN
# pwd
Solaris responds as follows:
/opt/OV/bin
3 Change to the directory that contains the integration files.
# cd $TCMHOME/ovw
4 Install the integration files.
# ./Install
You can run the $TCMHOME/ovw/Install script at any time. You do not need
to run $TCMHOME/ovw/Remove before running $TCMHOME/ovw/Install
again.
HP OpenView integrates the IP Telephony Manager icons; this lets you access IP
Telephony Manager from HP OpenView.
Fixing Incorrect Maps If you populate CommWorks devices in OpenView before you installed IP
Telephony Manager, IP Telephony Manager integration does not change the
component type from a non-CommWorks type to a CommWorks chassis type.
You cannot do this automatically in HP OpenView. For best results, delete and
rediscover the CommWorks devices.
You can also use the OpenView ovtopofix -r -o <object id> command.
CommWorks object IDs 1.3.6.1.4.1.429.2.1 through 1.3.6.1.4.1.429.2.9 must
each be individually specified.