3Com CommWorks 5210 - Manual (Page 97)

Execution Errors 97
Selected device is not a modem
The target slot is not a modem.
Channel number out of range: <number>
The target channel number is invalid for the particular type of card.
No DS0 assigned to modem. Test aborted.
The modem does not have a time slot assignment and tone test is therefore
impossible.
Extra targets, only the first will be used
The user selected more than one modem when invoking a tone test. The first
specified modem will be used, and the others ignored. (Warning only)
Extra command argument after target: <string>
Unused information was seen at the end of the command line and will be
ignored. (Warning only)
Receive ignores frequency/amplitude command arguments
Receive Tone was invoked with frequency/amplitude arguments, which will be
ignored. (Warning only)
Test in progress. Stop it before exiting?
Issued in a "Yes/No" dialog when user quits from window frame while a tone
test is in progress. (GUI, warning only)
Trap Destination The following are the Trap Destination error messages and what they indicate.
Invalid IP address: <ip-addr>
The IP address entered is not a valid dot-notation IP address or host name in
the host database.
You must enter an IP Address!
When adding a trap destination, the user entered a blank IP address/host
name. (GUI only)
String ’invalid’ may not be used
The community string ’invalid’ is a reserved value and is not allowed to be
entered as data. (GUI only)
Community string too long. Truncate?
Issued in an "OK/Cancel" dialog when a community string and/or comment is
entered that is too long. (GUI, warning only)
Comment too long. Truncate?
Issued in an "OK/Cancel" dialog when a community string and/or comment is
entered that is too long. (GUI, warning only)