3Com CommWorks 5210 - Manual (Page 84)

84 A PPENDIX : E RROR M ESSAGES
Invocation Errors This topic describes the error messages that can occur from a command syntax
error.
The invocation errors categories listed here are:
■
Command Line Target Selection
■
Chassis Restore
■
Chassis Save
■
Command Tool
■
Configuration Tool
■
Software Download
■
Test Tool
■
IP Telephony Manager Console
■
Tone Send/Receive
■
Trap Destination
Command Line Target
Selection
The following are the Command Line Target Selection error messages and a
description of what they indicate.
Range out of order <target specification>
A range is backwards (e.g., S5-3 instead of S3-5).
Slot selection is not allowed <target specification>
The application cannot be invoked at the slot level.
Channel selection is not allowed <target specification>
The application cannot be invoked at channel level (e.g., software download).
Time slot selection is not allowed <target specification>
The application cannot be invoked at time slot level. (True for all except
commands.)
Slot number out of range <target specification>
A slot number refers to a slot out of range for the given type of chassis. (e.g.,
slot 10 in a 7-slot chassis.
Channel number out of range <target specification>
A large channel number (not valid for any IP Telephony Manager card) was
specified.
Channel number out of range at slot <target specification>
A channel number refers to a channel not present on the given type of card in
the selected slot.