3Com CommWorks 5210 - Manual (Page 94)

94 A PPENDIX : E RROR M ESSAGES
There are no commands for this type of device.
The device configuration files do not list any commands for the target device.
Invalid group name: <name>
The device configuration files do not list <name> as a valid group.
Invalid command: <name>
The device configuration files do not list <name> as a valid command within
the current group.
Slot <number> T1/PRI query: <specific error>
An error occurred in trying to verify or solicit a time slot range specified against
a T1 or ISDN card.
Invalid time slot range for card: <specification>
The user specified a time slot range which includes time slot numbers not valid
for the given type of card.
Command Specific Parameter exceeds maximum length of <length>
The user entered a command parameter that was too long (GUI only). The
command will not be executed.
Slot <number>: graphical selection of time slots in this card is not supported.
IP Telephony Manager is not able to present a selection dialog for the given
card. (The card type is not supported by this particular version of IP Telephony
Manager.)
<target>: Non-command operation
Reported in the command tool final summary when a modem test or other
non-command result is in the target’s result table. (Non-GUI, warning only.)
Cancel Execution and exit program?
Issued in a "Yes/No" dialog when user quits from window frame while
command/test is in progress. (GUI, warning only)
Program exit during execution
The command or test program was terminated (e.g., by a signal) while a
command or test was in progress. (Non-GUI, warning only)
Configuration Tool The following are the Configuration Tool error messages and what they
indicate.
This device is not the same type as target(s).
The "load from" source does not match the target devices whose new values
are to be loaded.