3Com CommWorks 5210 - Manual (Page 77)

Setting Manual Switchovers 77
For the Back-end Servers:
■
Accounting Server—restart 3Com Accounting service on IP Telephony
Manager, or stop and start 3Com VoIP Accounting Data service applet on
the Windows NT machine.
■
Directory Mapping Server—restart 3Com Directory service on IP Telephony
Manager, or stop and start 3Com VoIP Directory Data service applet on the
Windows NT machine.
■
Provisioning Server—restart MS web server on IP Telephony Manager, or
stop and start World Wide Web Publishing service applet on the Windows
NT machine.
Setting Manual
Switchovers You can force the Gatekeeper to manually switch-over to another Accounting,
Directory Mapping, or Authentication Server.
To set the manual switchover:
1 Using IP Telephony Manager, open the Media Gateway chassis.
2 Click File, and then click Open.
3 Select the Gatekeeper you are configuring from the Device List. If the
Gatekeeper is not listed, see Connecting to Entities in Chapter 1.
4 Click OK.
5 Select the server graphic.
6 Click Actions/Commands from the Configuration menu.
7 When prompted to select an entity, click 3Com Gatekeeper in the list box,
and then click OK.
The Command Tool dialog box appears.
8 Click Switchover Commands in the Category drop-down list.
9 From the Command to Execute drop-down list select Switch Accounting,
Switch Directory, or Switch Authentication.
10 Enter the IP address of the new server in the Command Specific Parameter
field.
11 Click Execute and wait for a successful completion of the command.
The server switch-over has been set.
12 Repeat steps 10 through 12 for each server type to manually switchover.
13 Click Close.
A real time table appears and displays the selected Media Gateway and the
Gatekeeper to which it is registered. The IP address is of the Gatekeeper to
which it is registered is also displayed.