3Com CommWorks 5210 - Manual (Page 85)

Invocation Errors 85
Channel range contains zero: <target specification>
A channel range includes 0 (e.g., S1C0-2).
Time slot range contains zero: <target specification>
A time slot range contains zero.
Expected slot-level target: <target specification>
The target specification began with a slot-level target but also has targets at
some other level.
Expected time slot-level target: <target specification>
The target specification began with a time slot-level target but also has targets
at some other level.
Slot <number> empty: <target specification>
There is no card in the specified slot, based on information available at the last
discovery or IP Telephony Manager Console poll.
Unknown card in slot <number>
The card in the specified slot is unknown and the application does not allow
operation against unknown cards.
Mismatched targets: slot <number>, slot <number>
The two slots contain cards that are not compatible for the present
application’s purposes.
Time slot selection not applicable: <target specification>
There is no time slot-level support for the particular card for which a time slot
specification was given (e.g., the card is not a T1 or ISDN card).
Chassis Restore The following are the Chassis Restore error messages and what they indicate.
No target specified
The user did not supply an IP address or host name on the command line.
Too many targets specified
The user specified more than one IP address/host name (there is more than one
white space-separated word in the target list).
Chassis Save The following are the Chassis Save error messages and what they indicate.
Unknown target name or IP address format
The target does not specify a valid IP address or host name.