3Com CommWorks 5210 - Manual (Page 119)

Feature Enable 119
Feature Enable The following command line launches the Feature Enable option:
tcminv [-l logfile] [-h] [-c readcomm] [-C writecomm]
[ target]
Where:
-l logfile
The log file for system diagnostic messages.
The GUI log file default is the UNIX syslog file. The CLI default is stderr. You can
reverse these defaults by specifying a "-" (hyphen).
-h
Displays the command line parameters and the descriptions of the parameters
and their flags.
-c readcomm
The SNMP read community string.
-C writecomm
The SNMP write community string.
target
An optional parameter that specifies the chassis device to be feature enabled
If no target is specified, the GUI presents the file selection dialog and proceeds
with file-based feature enable. If the target is specified, the GUI invokes
manual feature enable.
The format for target is as follows:
< IP-host>[:S<slot>]
SIG Software Download utility received
a UNIX signal Signal received. IP Telephony
Manager/Solaris catches the following
signals (to avoid termination): PIPE,
TERM, USR1, and USR2.
END Utility is terminated
Table 13 Software Download Progress Message Descriptions (continued)
Message Description Additional Information