3Com CommWorks 5210 - Manual (Page 22)

22 C HAPTER 1: I NSTALLATION
Starting IP Telephony
Manager After you complete the installation and modify the path statement, you can
start IP Telephony Manager.
To start the IP Telephony Manager, from the command line prompt, type one
of these commands:
# xtcmvfpd
or
# xtcmvfpd <target chassis IP address>
The first command causes a list of the chassis components to display. You can
then select the component that you want to start. The second command
specifies the IP address of the component that you want started.
The IP Telephony Manager graphical user interface (GUI) opens a virtual display
of the target chassis. If the virtual display does not appear, set and export the
paths according to the instructions in this chapter.
For a complete description of the menus on the GUI, refer to Chapter 3
Navigating and Using the System .
Connecting to
Entities CommWorks IP Telephony Manager lets you configure and monitor any
CommWorks IP Telephony entity (for example the Media Gateway,
Gatekeeper, Accounting Server, Billing Support Server.) on your system. To
connect to the individual entities:
1 Start IP Telephony Manager.
2 Click File, and click Open, and then click New from the IP Telephony Manger
Console window.
3 Enter the name and IP address of the entity.
4 Verify that the community strings are as follows:
■
Read-only is public (case sensitive)
■
Read/write is private (case sensitive)
To modify these default settings, refer to Chapter 4, topic: Changing the SNMP
Community Strings .
5 Click OK.