3Com CommWorks 5210 - Manual (Page 59)

Configuration Menu 59
■
Exit—Closes the window and displays the previous window.
■
Adjusting Column Width—You can adjust the column width using the
mouse. Place the cursor over the column divisor line until it changes to a
bar and arrow, then click and drag the line left or right.
Action/Commands
Submenu
The Action/Commands submenu displays the Command Tool window for the
selected entity.
Figure 34 shows an example of the CommWorks EdgeServer Pro entity.
Figure 34 Command Tool Window
The Command Tool window contains the following fields and control buttons:
■
Selected Targets—Displays the card type, the slots, and channels that
receives the command.
■
Category—Some cards have different command categories. If the selected
targets have only one command category, this box is grayed out.
■
Command to Execute—Click this box to select the command you want to
execute for the selected targets.
■
Force Command—The card may be in a state where the selected
command is normally rejected (for example, a modem in dial mode). Check
this box to override this lockout.
■
Command Specific Parameter—Commands for some device types
require an additional parameter to be specified when the command is
issued. his parameter is not required for the Total Control chassis.
■
Issued—Indicates whether or not the command was successfully initiated.
■
Result—Indicates the results of the last executed command.
■
Comment—Displays details about failed commands.