Garmin NavTalk Pilot - Manual (Page 136)

122
Section 6
GPS Receiver
Reference
‘Battery Timer’ provides a running count of how long
the unit has been in operation with the current batteries.
The timer automatically stops when using an external
power source. The timer can be reset manually.
To select a battery timer setting:
1. Highlight the ‘Battery Timer’ field in the right-hand
column and press ENTER.
2. Select ‘Off’, ‘On’ or ‘Reset’ and press ENTER.
‘Since Midnight’ provides a running count of how
long the unit has been in operation since midnight of the
current day.
‘Since Factory Reset’ provides a running count of
total operating time since the receiver was shipped from
the factory.
Emergency— The NavTalk Pilot can be programmed
to auto-dial an emergency number such as 911, a security
agency, or other emergency assistance service. The unit
will allow emergency auto-dialing even if the unit is
“Locked”. Press and hold the red “9“ key for more than
two seconds. If you want to cancel before the call is
connected, press END.
To Program Emergency Calling:
1. Press the MENU key twice to access the Menu page.
2. Scroll down to Emergency and press ENTER. The
Emergency programming page will appear.
3. Move the cursor to the Emergency number field and
press ENTER. Use the phone keypad to enter the
desired number. You may enter 911 or an
emergency number of your choice, then press
ENTER to record. If the padlock icon is closed you
must enter the “Security Lock Code” to open before
accessing the number field.
4. Cursor to the “Feature Enabled” box and press
ENTER to enable Emergency Calling. If you want to
secure the emergency number use your security code
to lock the padlock icon before exiting the page.
Reset the battery timer
when the battery is
fully charged.
Emergency
Programming Page