Garmin NavTalk Pilot - Manual (Page 44)

30
Section 3
Basic Phone
Operation
• Alternating High/Low Tone
— The cellular system
could not complete the call. You may have tried to
place a call before the NavTalk Pilot was fully
operative or poor signal strength is preventing the
celluar system from receiving the NavTalk Pilot
signal. To correct, press SEND to immediately redial
the call, or press END and dial the number again.
• Busy signal
— The called party’s phone is busy.
Dialing Errors
If you make an error while entering a phone number
press the left arrow key of the arrow keypad to delete the
last number. To delete the entire entry, press and hold the
left arrow key of the arrow keypad or END. Now you can
re-enter the number you want to call.
Auto-Redial
The phone features ‘Auto-Redial’ which makes it
possible for you to repeat call attempts when the cellular
system is busy. If you receive an alternating high/low
signal or the fast busy tone when attempting to place a
call and wish to retry the call you can program the phone
to redial the number. The phone recognizes that the call
was not completed, then it redials every 15 seconds. You
can program this feature to redial up to nine times. If you
do not want automatic redialing, press END at any time.
‘Auto-Redial’ is programmed in the Phone setup page
accessed from the Setup portion of the Main Menu. See
page 41 for information.
Ending a Call
To end a call Press END.
Missed Calls Indicator
The NavTalk Pilot counts up to 20 unanswered and
Auto Pager calls. The number of missed calls are
displayed below the telephone icon located in the message
center on the Cellular Status Page.
Important!
The NavTalk Pilot does
not have an extendible
antenna. Hold the phone
as you would any other
telephone. While speaking
into the mouthpiece,
position the antenna up
and over your shoulder.
Do not hold the antenna
or allow it to come into
contact with any other
object while making a call
or while talking. This can
affect call quality.