Garmin NavTalk Pilot - Manual (Page 57)

43
Section 4
Cell Phone
Reference
Programming Phone Setup (Answer Mode,
Auto Redial, Auto Data and Calling Card PIN)
There are three Answer Mode options, Manual Answer,
Auto Answer (Hands-Free, for headsets) and Auto Pager.
When Auto Pager answers, the microphone is muted and
the unit emits a beep tone to indicate the Auto Pager feature
is active. The caller then enters their phone number that is
placed in the ‘Missed Calls’ list along with a date/time
stamp. Inform frequent callers about the Auto Pager beep
tone signal. Pressing SEND pre-empts Auto Pager.
Pressing END before answering any call cancels Auto
Answer or Auto Pager. These two modes then resume for
subsequent calls. Auto Redial allows you to redial the
number you are calling up to nine times.
Auto Data provides for location data transmission
without ringing the phone or requiring the SEND key to
be pressed, and without displaying messages about
location transfer. If data is not detected within three
seconds, the call will ring for up to 50 seconds and is
treated according to user selection (Auto Answer, Auto
Pager or Manual Answer). Auto Data selection can be
locked and unlocked using the Security Password.
To program Answer Mode:
1. Use the down arrow key to highlight the field.
2. Press ENTER to display Manual Answer, Auto-
Answer or Auto-Pager from the pop-up menu.
3. If choosing Auto Answer or Auto Pager, press the
right arrow key to move to the Number of Rings
field, press ENTER and then use the up arrow key
or phone keypad to enter the number of rings. You
are limited to nine rings. Press ENTER to store your
selection.
Highlight ‘Answer Mode”
and press ENTER to
display the pop-up
Options Menu for phone
answering modes.
Highlight the desired
option and press ENTER.
The Auto Data and PIN
selection fields require
unlocking, using the
Security Password