Garmin NavTalk Pilot - Manual (Page 97)

83
Section 6
GPS Receiver
Reference
3. To enable/disable automatic zoom, select the next
‘Map’ tab and press ENTER. Highlight the ‘Auto
Zoom’ field and press ENTER. Select ‘On’ or ‘Off to
enable or disable automatic zoom. Press ENTER to
accept the selected option. When ‘On’, the
automatic zoom feature automatically adjusts the
map scale from 30 nm through each lower scale,
stopping at 0.2 nm as you approach your destina-
tion waypoint.
4. To enable/disable all land data or aviation data,
select the ‘Source’ tab, highlight the appropriate
field and press ENTER. The ‘Aviat’n Data’
(Jeppesen Data) is selectable as ON, OFF or Air On
(default setting.) On means the data will be on all
the time (subject to Map Setup filtering). Off means
the data will be off all the time. Air On means that
this data will be displayed only when the unit is
placed in the aircraft cradle (i.e. Air On – Aircraft
mode only.) The MapSource data is selectable as
On, Off or Gnd On (default setting.) On means the
data will be on all the time (subject to Map Setup
filtering). Off means the data will be off all the time.
‘Gnd On’ means that this data will be displayed only
when the unit is in the ground mode (i.e. ‘Gnd On’
– Ground mode only or not in the aircraft cradle.)
These settings allow you to display map data
according to your preference. If declutter is
important then the settings of Air On/Gnd On will
turn the Jeppesen Data and MapSource data On or
Off automatically as the unit is used in or out of the
aircraft cradle. If you like to see all the data all the
time, then set all types of data to On.
5. For airports, navaids, active route waypoints, user
waypoints, state/provincial boundaries, rivers/lakes
and cities: select the appropriate tab and press
ENTER. Highlight the zoom field for the desired
feature and press ENTER. Select the maximum
scale at which you want the feature to appear on
screen (or ‘Off’ to never display) and press ENTER.
Highlight the text field on appropriate tabs for the
desired feature and press ENTER. Select the text
size for small, medium, or large as desired or ‘None’
to disable text, and press ENTER.
Selecting the ‘Track Up’
option makes the map
rotate so the direction
you’re heading is
always at the top.
‘North Up’ will keep
the top of the map
display oriented north.
The automatic zoom
setting steps the map
scale down through
each lower scale as you
approach your
destination waypoint.
.