Garmin NavTalk Pilot - Manual (Page 65)

51
Section 4
Cell Phone
Reference
The Minute Reminder
will emit two beeps each
minute unless turned Off
To enable Remote Command:
1. Press the MENU key twice to access the Main
Menu.
2. Cursor to the Setup Menu option and press ENTER.
3. Select the System Setup Page tab, then cursor down
to the padlock icon above the ‘Remote Command’
field.
4. If the icon is locked, highlight it and press ENTER to
pop up the Security window. Enter your Lock Code
to open the lock. If the icon is not locked cursor to
the ‘Remote Command’ field and press ENTER to
enable or disable this feature.
To “Query” for a GPS location:
1. Dial the number of a NavTalk Pilot unit or similarly
programmed cellular device. When the called
number answers press MENU and cursor to ‘Query
Location’ and press ENTER. You will hear the
DTMF tones and the “Transferring Location”
message will appear.
2. When the DTMF tone has been recognized, the
other unit will transmit the GPS location to your
unit, but only if it has the ‘Remote Command’
feature enabled. If it is not, the tones will stop and
the new position will not be acknowledged. If the
call is disconnected before the transfer is complete,
the new position will not be acknowledged.
3. The new position is acknowledged by a confirma-
tion message and the location marked as a “Phone”
waypoint on the Map Page. Refer to Page 56 for
more information.
Setting Call Timers
Call Timers are useful for recording the time of the
last call you made, the elapsed time of all calls for a
measured time period, and the total lifetime use of your
NavTalk Pilot call time. You can also set the unit to signal
each time a minute of your current call has elapsed.