Garmin NavTalk Pilot - Manual (Page 29)

15
Section 2
Getting
Started
Tour
Turning the NavTalk Pilot On and Off
1. Press and hold the PWR key to turn the NavTalk
Pilot on.
2. Press and hold the PWR key to turn the NavTalk
Pilot off.
Each time the Navtalk Pilot is turned on, the
Welcome Page will appear while the unit conducts a self
test. A Database Information Page and Warning Page
appear, asking you to read and acknowledge important
information regarding the proper use of the land data that
is provided.
After approximately ten seconds, the Land Data
Warning Page will be replaced by the Cellular Status Page.
Press the PAGE or ENTER key twice to bypass these
pages. (If the Satellite Status Page appears instead of the
Cellular Status Page, it’s because the unit was in the GPS
receiver mode when it was turned off.) Refer to page 61
for more information on initialization.
To Switch from the Cellular to GPS Modes
1. Press the GPS/PHONE Mode key. Toggle the key to
switch back and forth from GPS to Cellular.
At this point you may want to adjust the screen
contrast which you can do by selecting the GPS mode
Satellite Status Page or Cellular Mode Status Page.
To Adjust the Screen Contrast
1. Press the PAGE key until you access either the
Cellular Status page in the Phone Mode or the
Satellite Status Page in the GPS Mode. Press the
right arrow of the ARROW keypad. A pop up
sliding indicator will appear. To increase the
contrast, move the indicator to the right by pressing
the right arrow key.
2. To decrease the screen contrast, press the left arrow
of the ARROW keypad. Press the PAGE key to
finish.
Contrast adjustment is also available from the Setup
Menu/System Page (see page 50.)
PWR
Key
Greeting
Page
Contrast Adjustment
Warning
Page