Garmin NavTalk Pilot - Manual (Page 58)

44
Section 4
Cell Phone
Reference
To program Auto-Redial:
1. Use the ARROW keypad to highlight the On/Off
field and press ENTER.
2. Highlight On or Off and press ENTER.
3. If you selected On, move to the Number of Times field
and press ENTER. Use the ARROW or phone keypad
to set the number of times you would like to redial any
given number (the maximum is nine), then press
ENTER. A “Redial” prompt will appear when active.
To program Auto Data:
1. Highlight the padlock icon and press ENTER. A pop
up window will appear at the base of the display.
Press ENTER to key in your password. After you
have keyed in the password press ENTER and
observe that the icon is now open and a PIN
window appears at the base of the display.
2. Use the ARROW keypad to highlight the ‘Auto
Data’ field and then press the ENTER key. To
secure repeat Step 1.
To enter your Calling Card Access PIN into the
phone programming:
To automate calling card dialing you can store your
PIN number in the unit for entry into a dialing string as a
code “C” as explained on pages 53 through 54. Your PIN
is password protected. Refer to “Security” page 45.
1. Repeat the steps above for programming Auto Data.
2. Move to the PIN field and enter your PIN, then press
ENTER.
3. Cursor back to the icon and press ENTER. Press
ENTER again when the password window appears.
Enter your password and then press ENTER. The
lock icon will close and your displayed PIN will be
hidden, but can be inserted in a call dial string by
using the “C” code (see page 54.)
Padlock icon open and
PIN field open for PIN
entry. After entry, close
padlock icon and the field
will be closed to viewing.
The Auto-Data switch can
be turned On or Off using
the Security Password
Phone Set-Up Directory
programmed for Auto-
Pager after 2 Rings and
Auto-Redial turned Off