Garmin NavTalk Pilot - Manual (Page 158)

144
Messages
Appendix D
Need to Select Init Method— You must select an initialization method so
the unit can locate satellites and obtain a GPS position fix.
New Missed Call— An unanswered call was received and stored on the
Missed Calls List.
No Differential GPS Position— Not enough data is available to compute a
DGPS position.
No Service— You are out of your phone service cell or there is interference
blocking the cell signal, phone mode turned off or unit is scanning.
Off Course Alarm— You are left or right of course, beyond the limits set on
the Alarms submenu
Oscillator Needs Adjustment— The NavTalk Pilot has detected excessive
drift in its internal crystal oscillator which may result in longer acquisition time.
The unit should be taken to an authorized GARMIN dealer.
PhoneBook Memory Full— There is no more space to enter new names in
the PhoneBook.
Poor GPS Coverage— The NavTalk Pilot cannot acquire the necessary
number of satellites to compute a position. Try another location with a clearer
view of the sky.
Power Down and Re-init— The NavTalk Pilot cannot calculate a position
due to abnormal satellite conditions.Turn power off and use other means to verify
the last position shown. Try the unit again later, possibly in a different location.
RAM Failed— The NavTalk Pilot has detected a failure in its internal
memory. If the message persists, the unit is unusable and should be taken to an
authorized GARMIN dealer.
Received Invalid Waypoint— A waypoint was received during upload
transfer that has an invalid identifier.
GPS Receiver Failed— A failure in receiver hardware has been detected. If
this message persists, do not use the unit. Take it to an authorized GARMIN
dealer.
ROM Failed— The permanent memory has failed and the unit is not
operable. Take it to an authorized GARMIN dealer.
Route Already Exists— You have attempted to name a route with the same
name currently in use with an existing route. Enter a different name for the route.