How to assign a channel from the channel field, How to assign a channel from the shuttlepro, 16 loading media – EVS IPDirector Version 4.4 - March 2008 Part 3 User's Manual User Manual
Page 88: 1 how to load a train in the control panel, 16 "loading media
IP Director Version 4.4 – User Manual – Part 3: Ingest and Play-Out
EVS Broadcast Equipment – March 2008
Issue 4.4.C
75
H
OW TO
A
SSIGN A
C
HANNEL
F
ROM THE
C
HANNEL
F
IELD
To assign a channel from the Control Panel, proceed as follows:
1.
Right-click on the Channel field.
2.
Select the channel to assign from the contextual menu that displays the
available channels.
H
OW TO
A
SSIGN A
C
HANNEL
F
ROM THE
S
HUTTLE
PRO
To assign a channel from the Shuttle PRO, proceed as follows:
1.
Press the Select Player key on the ShuttlePRO controller.
This calls up a list of channels available to be controlled.
2.
Use the jog dial to move through the list and highlight the required
channel.
3.
Press the Select Player key again to assign the channel and exit the
menu.
Refer to the ShuttlePRO section of the manual for more information on the
configuration of the controller.
4.16 LOADING MEDIA
4.16.1 H
OW TO
L
OAD A
T
RAIN IN THE
C
ONTROL
P
ANEL
To load a record train in the Control Panel, proceed as follows:
1.
Open the Channel Explorer from the main menu.
2.
Select the requested record train in the structure of the XNet network.
3.
Drag it to the Loaded Media field of the Control Panel.
The train is loaded in the Control Panel at the current timecode.