Velleman HPS50 - Manual (Page 26)

26
HPS50 PersonalScope TM Setup
Fig 19
3 4
3. Display mode
Dynamic: The screen layout changes automatical-
ly to show the best signal resolution, depending on
X position shift and the position of the markers.
See also “using the markers”
Manual: The screen layout remains fixed accor-
ding to your selection.
4. Send mode
ASCII: a file with settings and samples (relative
value 0 to 255) is send after power on or during
roll mode. This setting is normally used in
conjunction with a terminal program.
Binary: As above, but data are output in a binary
form. Use this setting with special software, check
our web site.