Grain Systems Bin Accessories PNEG-1802 - Manual (Page 13)

4. Inside Ladder Installation
PNEG-1802 Inside Ladder Instructions 13
Inside Starter Bracket and Ladder Placement
Refer to Figure 4B and follow the correct dimensions as shown. The ladder starter brackets must be
located in line with the horizontal seam. Check the 4' ladder section to make sure the ladder rung dimples
are to the top surface and attach to the starter brackets using the hole located 1" from top of the ladder.
Now all standoff brackets must be installed every 16" and attached to each 4' section required.
(See Figure 4C on Page 14.)
Figure 4B