Grain Systems Bin Accessories PNEG-1802 - Manual (Page 46)

4. Inside Ladder Installation
46 PNEG-1802 Inside Ladder Instructions
Inside Starter Bracket and Ladder Placement
Refer to Figure 4AR and follow the correct dimensions as shown. The ladder starter brackets must be
located in line with the horizontal seam. Check the 4' ladder section to make sure the ladder rung dimples
are to the top. Attach to the starter brackets using the hole located 1" from top of the ladder. Now all
standoff brackets must be installed every 22" and attached to each 4' section required.
Figure 4AR Inside Starter Bracket and Ladder Placement
NOTE: Refer to general detail information section on PNEG-1451 for additional details for standoff bracket
to ladder assembly.