Grain Systems Bin Accessories PNEG-1802 - Manual (Page 38)

4. Inside Ladder Installation
38 PNEG-1802 Inside Ladder Instructions
Inside Ladder Standoff Bracket/Supports
Inside Ladder Standoff
Bracket Requirements
For the standoff brackets, field drill two (2)
3/8" diameter holes 18-3/4" apart directly in
line with the horizontal seam holes. Continue
down the sidewall with standoff brackets
every 16". Refer to
Figure 4AG .
Figure 4AG
Inside Ladder Supports
After completing the inside ladder, be sure
to support the bottom of the ladder to the
concrete. Depending on the actual installation,
the amount of support required may vary.
Supports are not supplied by the manufacturer.
If a bin sweep is to be used in the grain bin,
other considerations may be necessary to
assure there is no interference with the
equipment. Refer to
Figure 4AH .
Figure 4AH