Grain Systems Bin Accessories PNEG-1802 - Manual (Page 25)

4. Inside Ladder Installation
PNEG-1802 Inside Ladder Instructions 25
Inside Starter Bracket and Ladder Placement
Refer to Figure 4R and follow the correct dimensions as shown. The ladder starter brackets must be
located in line with the horizontal seam. Check the 4' ladder section to make sure the ladder rung dimples
are to the top surface and attach to the starter brackets using the hole located 1" from top of the ladder.
Now all standoff brackets must be installed every 22" and attached to each 4' section required.
NOTE: Refer to general detail information section on PNEG-1420 for additional details for standoff bracket
to ladder assembly.
Figure 4R Inside Starter Bracket and Ladder Placement