Grain Systems Bin Accessories PNEG-1802 - Manual (Page 19)

4. Inside Ladder Installation
PNEG-1802 Inside Ladder Instructions 19
Inside Starter Bracket and Ladder Placement
Refer to Figure 4I and Figure 4J and follow the correct dimensions as shown. The ladder starter brackets
must be located in line with the horizontal seam. Check the 4' ladder section to make sure the ladder rung
dimples are to the top surface and attach to the starter brackets using the hole located 1" from top of the
ladder. Now all standoff brackets must be installed every 16" and attached to each 4' section required.
NOTE: Refer to general detail information section on PNEG-1420 for additional details for standoff bracket
to ladder assembly.
Figure 4I Inside Stiffened
Figure 4J Outside Stiffened