YSI 556 MPS - Manual (Page 133)

YSI Incorporated YSI 556 MPS Page 127
21. Appendix H Calibration Record Information
When your YSI 556 MPS sensors are initially calibrated, relevant
information about the sensors will be stored in a separate file in the YSI 556
MPS memory.
NOTE: This file, by default, will have the name “556 Circuit Board Serial
Number.glp.” The circuit board serial number is assigned at the factory and
has a hexadecimal format such as 000080A4. Thus the default calibration
record file would be designated 00080A4.glp. Refer to Section 10.7 GLP
Filename to change the filename.
The information in the calibration record will track the sensor performance
of your instrument and should be particularly useful for programs operating
under Good Laboratory Practices (GLP) protocols.
21.1 Viewing the Calibration Record (.glp) File
NOTE: Make certain that you have performed a calibration on at least one
of the sensors associated with your YSI 556 MPS.
Follow the procedures outlined in Section 8.3 View File.
21.2 Uploading the Calibration Record (.glp) File
NOTE: Make certain that you have performed a calibration on at least one
of the sensors associated with your YSI 556 MPS.
Follow the procedures outlined in Section 8.4 Upload to PC.
21.3 Understanding the Calibration Record (.glp) File
1. Open a calibration record file. Refer to Section 8.3 View File.
2. Use the arrow keys to scroll horizontally and/or vertically to
view all the data.