YSI 556 MPS User Manual
Page 36
Report
Section
5
YSI 556 MPS
YSI Incorporated
Page 30
Figure 5.2 Report Setup Screen
NOTE: A black dot to the left of a parameter indicates that
parameter is selected for display. Parameters with an empty
circle will not be displayed.
NOTE: You may have to scroll down past the bottom of the
screen to see all the parameters.
5. Use the arrow keys to highlight the parameter you want to
change, then press the Enter key. If you can't find the
parameter you want, even after scrolling down past the
bottom of the screen, the sensor used for that parameter is
disabled. Refer to Section 4 Sensors.
6. If you selected Temperature, Specific Conductivity,
Conductivity, Resistance or Total Dissolved Solids, the Units
screen will appear.
Figure 5.3 Units Screen
7. Use the arrow keys to select the units desired, then press the
Enter key to return to the report setup screen.
8. Repeat steps 5 and 6 for each parameter you want to change.