YSI 556 MPS - Manual (Page 78)

Section 9 Logging
YSI 556 MPS YSI Incorporated Page 72
9.5 Editing a Site List
1. Go to the logging setup screen as described in Section 9.1
Accessing the Logging Setup Screen.
2. Use the arrow keys to highlight the Edit Site List selection.
See Figure 9.6 Logging Setup Screen.
3. Press the Enter key. The edit site list screen is displayed.
4. Edit the site list using the keystrokes described below.
NOTE: Editing the site list will not have any effect on files
stored in the instrument memory.
Figure 9.1 Keystrokes for Editing Site List
To DELETE a site:
Use the arrow keys to
highlight a site. Press
the Left arrow key
while holding down
the Enter key.
To use the same file
name as the previous
site: Leave the
filename blank
Use the arrow keys to
highlight a site. Press
the Up or Down
arrow key while
holding down the
Enter key.
To MOVE a site:
To INSERT a site
above another site:
Use the arrow keys to
highlight the site.
Press the Right arrow
key while holding
down the Enter key.
Use keypad to input
letters. Refer to
Section 2.9 Keypad
Use.
9.6 Logging Data Without a Site List
1. Follow Steps 1 through 5 in Section 7.1 Real-Time Data.
2. Use the arrow keys to highlight the Log one sample selection
on the run screen if only a single sample is being logged.