Xylem pH/ION 3400i ION SELECTIVE ELECTRODE ANALYZER - Manual (Page 45)

pH/ 3400i Operation
45
As soon as all of the 500 storage locations are occupied, AutoStore is
terminated (Int 1 = OFF). If there are not enough storage locations
available for your measurements:
z Output and backup the data storage (see page 46) and
z Clear the memory (see page 52).
Note
The AutoStore function is interrupted if you start other functions, e.g.
output the data storage. After the function is finished, the AutoStore
function is continued. By this, however, temporal gaps in the recording
of the measured values will occur.
Switching off AutoStore Switch AutoStore off by:
z setting the save interval (Int 1) to OFF, or
z switching the measuring instrument off and then on again.
6 Set the required ID number with <
▲> <▼>.
7 Confirm with <RUN/ENTER>.
The measuring instrument switches to the last active measur-
ing mode and starts the measuring and saving procedure. Au-
toStore flashes on the display.
9
U
I
No. Day.Month
Year
pH
Time Baud
1
S
ISE
49
r E F
LoBat
RCL AR ARng
%
°F
°C TP
mV/pH
mol/L
TempError AutoCal DIN CalError
AutoCal TEC ConCal
mg/L
% ppm
1
Store Auto
Ident