Xylem pH/ION 3400i ION SELECTIVE ELECTRODE ANALYZER - Manual (Page 46)

Operation pH/ 3400i
46
4.6.3 Outputting the data storage
You can output the contents of the data storage:
z Stored data on the display
z Calibration data on the display
z Stored data on the serial interface
z Calibration protocol to the interface
Outputting stored data
on the display
You can perform the following activities:
1 Press the <RCL> key repeatedly until StO dISP appears on the
display.
2 Press the <RUN/ENTER> key.
A measured value appears on the display.
The storage location of the data record is displayed for approx.
2 s, then the respective temperature appears.
Display further data of the data record
(ID number, date, time, storage location) Press <RUN/ENTER>
Advance one data record
(storage location) Press <
▲>
Go back one data record (storage location) Press <
▼>
Store Auto
Ident
S
1
LoBat
Tref25
nLF
/ K %
Sal
°
AR
TP
C
M
m
% mg/l
cm
S/ cm
cm 1/
° F
ARng Cal Lin
Tref20
Sal TDS
mbar
O UpH
mV/pH
AutoCal DIN
AutoCal TEC
Time Baud
Day.Month No.
Year
p
S T O
d I s
RCL
mV/pH
mol/L
8
Auto Store TempError
LoBat
AutoCal DIN CalError
ARng AR AutoCal TEC ConCal
Time Baud
Day.Month No.
Ident Year
1
U
%
°F
S
mg/L
% ppm
ISE
8 4 2
6 86 6
°C TP
pH
RCL