Alpha Technologies XM2-300CE-HP - Manual (Page 37)

4.0 Operation, continued
4.3 Smart Display modes for XM2-300HP
4.3.1 Operation Normal
If no alarms are present, the XM2-300HP power supply operates in Operation Normal
display mode. In this mode you can view the primary operating parameters of the power
supply while the display auto scrolls through the available menu items at two-second
intervals. In Operation Normal mode the displayed items are all “metered” items and
are for informational purposes only (not programmable) with respect to the operational
status of the power supply.
The Operation Normal menu contains the following items:
Fig. 4-4, Operation Normal Display
(Examples are given for values in the display)
OPERATION NORMAL
OPER MODE = LINE
BATT STATUS OK
INV STATUS OK
DPM STATUS OK
INPUT VOLTAGE 120
INPUT FREq 60Hz
INPUT CURRENT 23.0A
INPUT WATTS 140
OUTPUT VOLTAGE 60
OUTPUT 1 CURR 1.0A
OUTPUT 2 CURR 1.0A
OUTPUT CURRENT 2.0A
OUTPUT WATTS 120 W
OUTPUT VA 120 VA
PERCENT LOAD 33%
CHARGER MODE = ACCEPT
BATT VOLTAGE 14.4V
BATTERy TEMP 26.5C
ENCLOSURE TEMP 26.5C
CHARGER CURR 5.0A
EST. BATT RUN < 60 MIN
1 EVENTS 84 MIN
Top line
Second line
The top line indicates the current screen and provides additional instructions. Use the
arrows to manually scroll.
The second line cycles through the parameters listed above.
*
Only visible in single-step mode
*
*
*
37 017-877-B1-001 Rev. A