Alpha Technologies XM2-300CE-HP - Manual (Page 38)

Fig. 4-5, Comms Info Display
(Examples are given for values in the display)
4.0 Operation, continued
4.3
Smart Display modes for XM2-300HP, continued
4.3.2 Comms Information Display (with DPM)
Pressing ENTER while in the Operation Normal screen will open the Comms
Information display (only displayed when paired with DPM, otherwise display will
read “NO DATA”). This mode operates in a similar fashion as the Operation Normal
display. When you first access the information display, information displays in Auto
Scroll mode. Press UP or DOWN to access information one step at a time. Press
ENTER to access the Setup Menu (discussed in Section 4.3.3, Setup Menu). Press
ESCAPE to reactivate Auto Scroll mode. Press ESCAPE a second time to reactivate
Operation Normal mode (up one level).
The Comms Information display contains the following items:
COMMS INFO
CM 00:90:EA:12:34:56
CPE 00:90:EA:12:34:57
CM 192.168.123.123
CPE 192.168.123.124
CM RX PWR -12.9 DBMV
CM TX PWR 34.5 DBMV
DN FREq 300.000 MHz
UP FREq 15.000 MHz
MODEL DPM
SW XX.XX.XX.XX
Top line
Second line
The top line provides additional instructions. Use the arrows to manually scroll.
The second line cycles through the parameters listed above.
*
Only visible in dual-IP configurations
*
*
DPM Firmware
Version; change
location in menu
38 017-877-B1-001 Rev. A