DE-STA-CO IM-pAC AC Drive Getting Started Guide - Manual (Page 3)

IM-pAC Getting Started Guide 3
Issue Number: 5 www.camcoindex.com | www.destaco.com
Contents
1 Read Me First Instructions .................................................6
1.1 Data Sheet ..............................................................................................6
1.2 Drive Size ................................................................................................6
1.3 Safety ......................................................................................................6
1.4 Mounting of Drive ....................................................................................6
1.5 Wiring Motor ............................................................................................6
1.6 Motor Jumper Configuration for 1/3 hp and 1.00 hp motors ...................7
1.7 Wiring Power and Switches to Drive .......................................................7
1.8 Programming ...........................................................................................8
1.9 Speed Control .........................................................................................8
1.10 Overload Protection .................................................................................9
1.11 Brake Motors ...........................................................................................9
1.12 Reversing the Motor ................................................................................9
1.13 Emergency Stop Safety ...........................................................................9
1.14 Warranty and Return Policy ....................................................................9
1.15 Disposal ...................................................................................................9
1.16 Indexer drive shown in middle of dwell position diagram. .......................9
1.17 Drive default parameter list for a single preset speed application .........10
1.18 Drive parameter list for using a potentiometer to control speed ............12
1.19 Drive parameter list for using a potentiometer to control speed with a
proximity switch for cycling ....................................................................14
1.20 Drive parameter list for using a potentiometer and switch selected
presets to control speed ........................................................................17
1.21 Drive wiring for using a potentiometer and switch selected presets to
control speed .........................................................................................19
1.22 Drive parameter list for using a PLC to control speed ...........................20
1.23 Drive wiring for a PLC to control speed .................................................21
1.24 How to configure the IM-pAC drive to trip for a current overload. .........22
1.25 Drive parameter list for a motor reversing application ...........................24
1.26 Drive wiring for a motor reversing application. ......................................27
1.27 Drive parameter list for a 24Vdc brake motor ........................................28
1.28 Drive wiring for a 24Vdc brake motor ....................................................30
1.29 Drive and Options part numbers ...........................................................31
2 Safety Information .............................................................32
2.1 Warnings, Cautions and Notes ..............................................................32
2.2 Electrical Safety - general warning ........................................................32
2.3 System design and safety of personnel ................................................32
2.4 Environmental Limits .............................................................................32
2.5 Access ...................................................................................................33
2.6 Compliance and regulations ..................................................................33
2.7 Motor .....................................................................................................33
2.8 Adjusting parameters ............................................................................33
2.9 Electrical installation ..............................................................................33