DE-STA-CO IM-pAC AC Drive Getting Started Guide - Manual (Page 49)

IM-pAC Getting Started Guide 49
Issue Number: 5 www.camcoindex.com | www.destaco.com
Re
ad
Me
F
irs
t
Instr
ucti
on
s
Sa
fety
Info
rm
atio
n
R
ati
ng
D
ata
Me
ch
an
ica
l
Inst
al
lati
on
El
ec
tric
al
In
stal
la
tion
Key
p
ad
a
n
d
D
isp
la
y
Pa
ra
m
ete
rs
Dia
gn
osti
cs
UL
Li
sti
ng
Info
rm
atio
n
6.6.1 Setting a security code
• Set Pr 10 to L2.
• Set Pr 25 to the desired security code e.g. 5
• Set Pr 10 to LoC.
• Press the MODE key
• Pr 10 will now be reset to L1 and Pr 25 will be reset to 0.
• The security code will now be locked into the drive.
• Security will also be set if the drive is powered down after a security code has been
set into Pr 25.
6.6.2 Unlocking a security code
• Select parameter to be edited
• Press the MODE key, the right hand display will flash 'CodE'
• Press the UP key to start entering the set security code. The left hand display
will show 'Co'
• Enter the correct security code
• Press the MODE key
• If the correct security code has been entered, the right hand display will flash and
can now be adjusted.
• If the security code has been entered incorrectly, the left hand display will flash the
parameter number. The above procedure should be followed again.
6.6.3 Re-locking security
When a security code has been unlocked and the required parameter changes made, to
re-lock the same security code:
•
Set Pr 10 to LoC
• Press the MODE key
6.6.4 Setting security back to 0 (zero) - no security
• Set Pr 10 to L2
• Go to Pr 25
• Unlock security as described above.
• Set Pr 25 to 0
• Press the MODE key.
M
M
M
M
M