DE-STA-CO IM-pAC AC Drive Getting Started Guide - Manual (Page 61)

IM-pAC Getting Started Guide 61
Issue Number: 5 www.camcoindex.com | www.destaco.com
Re
ad
Me
F
irs
t
Instr
ucti
on
s
Sa
fety
Info
rm
atio
n
R
ati
ng
D
ata
Me
ch
an
ica
l
Inst
al
lati
on
El
ec
tric
al
In
stal
la
tion
Ke
yp
ad
a
nd
Dis
pla
y
Pa
ram
e
te
rs
D
iag
no
stics
UL
Li
sti
ng
Info
rm
atio
n
measured, the drive may trip on OV and OI.AC while trying to catch a spinning motor.
dig : Digital input
th
: Motor thermistor input, connect as per diagram below
Fr
: Frequency input.
Fr.hr
:High resolution frequency input.
Figure 7-11
Trip resistance: 3kΩ
Reset resistance 1k8
n=0
: At zero speed
At.SP : At speed
Lo.SP : At minimum speed
hEAL
: Drive ok
Act
: Drive active
ALAr
: General drive alarm
I.Lt : Current limit active
At.Ld
: At 100% load
USEr
: User programmable
Fr : Voltage proportional to motor speed
Ld
: Voltage proportional to motor load
A
: Voltage proportional to output current
Por
: Voltage proportional to output power
USEr : User programmable
No Function Range Defaults Type
34 Terminal B7 mode select dig, th, Fr, Fr.hr 0:dig RW
0V
Motor thermistor
input
T1
B7
If Pr 34 is set to th so that terminal B7 is used as a motor thermistor, the functionality of
terminal B7 as set-up with Pr 05, drive configuration, will be disabled.
When setting to th, press mode four times. Analog reference 2 will no longer be selected
as the speed reference. Analog reference 1 should be used.
NOTE
No Function Range Defaults Type
35 Digital output control (terminal B3)
n=0, At.SP, Lo.SP, hEAL,
Act, ALAr, I.Lt, At.Ld, USEr
0:n=0 RW
This parameter is automatically changed by the setting of Pr 12. When Pr 12
automatically controls the setting of this parameter, this parameter cannot be changed.
NOTE
A change to this parameter is only implemented if the drive is disabled, stopped or
tripped and the STOP/RESET key is pressed for 1s.
NOTE
No Function Range Defaults Type
36 Analog output control (terminal B1) Fr, Ld, A, Por, USEr 0:Fr RW
A change to this parameter is only implemented if the drive is disabled, stopped or
tripped and the STOP/RESET key is pressed for 1s.
NOTE