Luminex xPONENT 3.1 Rev 2 - Manual (Page 40)

• Select a method from the Method list.
• If necessary, select a weight type from the Weight Type list.
• Apply the analysis to all analytes in the list by clicking Apply to All Analytes.
• Select Mark as Intra-Well Normalization Bead to make the analyte an intra-well
normalization bead.
• Add a range to the analysis by clicking Add Range.
• Select Use Threshold Ranges to enable ranges for the analysis.
• Click Add Range to add a range.
• Type a Range Name, a Low Value, a High Value, and select Inclusive if you wish to
include the low and high values in the range. Click OK to exit the dialog box.
• Units - The unit of measurement you specified in the Unit box. Click this box to type a
value for the analyte.
• Count - Type the desired bead count for the analytes by clicking in the Count box. If each
selected bead set does not acquire this number of events, a warning is added to the log
that not enough bead events were acquired.
• Region - Refers to the specific analyte selected. This is a number between 1 and 100.
Group - If you have selected Allele Call from the Analysis Type in the Settings tab, this
button displays. Click Group to group 2, 3, or 4 analytes for the group. Multiple groups can
be defined.
Cancel - Click Cancel to return to the Batches tab.
Back - Click Back to return to the Settings tab.
Next - Click to go to the next tab. If the Analysis Type selected in the Settings tab was
None or Allele, this takes you to the Plate Layout tab. If the Analysis Type selected was
Quantitative or Qualitative, this button takes you to the Stds & Ctrls tab.
Stds & Ctrls Tab
If you have specified standards and controls, use this tab to apply a lot or a kit. For more
information about the functionality of this tab, see “Stds & Ctrls Tab” section.
FIGURE 13. Batches Stds & Ctrls Tab
Touring the Software
27