FEC DSP1500 (SAN3) - Manual (Page 103)

PAGE ６－41
enFORCE Operation Manual
¾
Data Number 17 - Threshold Load
ƒ The starting point of calculation of 1 ST Rate.
ƒ This also sets the “Low” value when using 1 st Step Hi/Low check.
A setting is possible from 0 to 105% of full-scale value.
If rate supervision is not needed, set Threshold to the Full Scale Load
value. Threshold will not be detected, so rate supervision will not be
performed.
¾ Data Number 18 - Crossover Load
¾ Data Number 24 - Crossover Distance
ƒ The starting point of calculation of 2 ND Rate.
A setting is possible from 0 to 105% of full-scale value.
ƒ Crossover Distance can also be used as the end point for Slowdown Speed.
In Load Control methods:
In Distance Control methods:
Chapter 6: System Operation
Load
Distance
Threshold
1ST
Rate１Minimum
Rate１Maximum
Load
Distance
ＣＲＯＳ
Standard Load
Rate ２ Minimum
Rate ２ Maximum
Load
Distance
ＣＲＯＳ Target
Rate ２ Minimum
Rate ２ Maximum