FEC DSP1500 (SAN3) - Manual (Page 54)

PAGE ４－22
enFORCE Operation Manual
4.11 Firmware Flash Connector (CN8)
Upgrades or revisions to Firmware are handled easily with the on board Flash connector located on
the bottom of each SAN Unit. There is no need to remove or disassemble the unit. A Flash adapter
(SAN-ROM) containing the new firmware can be connected to connector CN8 with the power off to
the unit. The power is then cycled on and off with the adapter in place and the firmware is
automatically updated.
Note: This connector is for FEC use only and it is not recommended for use other than FEC.
CN 8
Bottom View of SAN Unit
Chapter 4: System Setup and Wiring