FEC DSP1500 (SAN3) - Manual (Page 96)

PAGE ６－34
enFORCE Operation Manual
♦ Distance Control with Load Limit (Method 7)
Upon start of cycle, the press will operate until it achieves [22: Standard Distance].
During the press cycle, after achieving [13: Standard Load], the press rate will be
current controlled to hold [13: Standard Load] until [22: Standard Distance] is
reached. During the press cycle, checks are performed for “1
ST Judgment Zone”, 1 ST
Rate, 2 ND Rate, Load, Distance, 1 ST Time and 2 ND Time. If any of these values are
compromised, the press will stop and return as programmed.
(See corresponding sections for Time, Rate, 1
ST Zone and Speed explanations.)
ƒ If “1 ST Judgment Zone” is not used, set [15: 1 ST Load] to [10: CAL Load] and
[23: 1 ST Distance] to a minimum of [21: High Distance].
ƒ Review Speed Section explanations and cautions when setting [15: 1 ST Load],
[14: Speed Change Load], [24: Crossover Distance] and [20: Freerun
Distance].
ƒ If 1 ST Rate or 2 ND Rate are not used, set judgment windows wide open; low value
of 0 and maximum high value. Also, if 1 ST H/L Check is not being used, set
[17: Threshold Load] to [10: CAL Load].
Chapter 6: System Operation
Load
Distance
[12] High Load Limit
[11] Low Load Limit
[13] Standard Load
[15] 1 ST Load
[14] Speed Change Load
[17] Threshold Load
[20]
Low
Distance
[21]
High
Distance
2 ND Rate
[41]
1 ST Time
[42]
2 ND Time
1 ST Rate
[23]
1 ST Distance
1ST Judgment Zone
Final Judgment Zone
[22]
Standard
Distance
[24]
Crossover
Distance