FEC DSP1500 Main Unit - Manual (Page 10)

x
Never operate the equipment with wet hands.
Failure to observe this instruction may cause electric shock.
Keep fingers away from the SAN Unit radiating fins and tool motor while the equipment is
turned ON or for a while after the equipment is turned OFF. These parts may become very
hot. Failure to observe this instruction may cause burns.
Use the equipment under the following conditions.
◆Ambient temperature: 0°C～+45°C (Avoid freezing)
◆Ambient humidity: 90% RH or lower (Avoid moisture)
◆Atmosphere: Indoors (Avoid direct sunlight)
No
corrosive gases or flammable gases
No oil mist, dust, water, salt, iron powder
◆Avoid direct vibration or shocks
Failure to observe this instruction may cause earth leakage and malfunction.
Confirm and adjust all parameters before operation in order to prevent unexpected
movement of the equipment.
Failure to observe this instruction may cause injury, false operation and malfunction.
Never conduct extreme adjustments or setting changes that may cause instability of
operation.
Failure to observe this instruction may cause injury, false operation and malfunction.
The equipment may restart suddenly when the equipment is reset with the start signal ON.
Always ensure that the start signal is OFF before resetting the equipment.
Failure to observe this instruction may cause injury.
Do not turn ON and OFF the equipment repeatedly.
Failure to observe this instruction may cause malfunction.
Do not use the equipment at loads higher than the maximum load.
Failure to observe this instruction may shorten equipment life or cause malfunction due to the
high temperature caused by overload.
The magnetic brake is for holding the press ram when performing maintenance procedures.
Do not use for normal braking otherwise failure may result.
The magnetic brake may fail to hold near the end of its life expectancy due to wear.
Secondary braking structures should be installed on the machine side to safely secure
otherwise injury may result.
In case any abnormality occurs, remove the cause and ensure safety before resetting and
restarting the equipment.
Failure to observe this instruction may cause injury.
Caution
Safety Precautions
Operation / Adjustment