FEC DSP1500 Main Unit - Manual (Page 33)

enFORCE DSP1500 Main Unit Hardware Manual
PAGE 4 - 7 (Rev. 4.0)
Chapter 4: Installation & Wiring
4.6.1 PC Port
The “PC” port is for communicating with the DSP Software in the User Console PC. The
connecting cable is a standard RS232 Null-Modem cable and can be purchased through FEC
(Part #FEB-1301) or through any authorized RS232 cable supplier. This port is not available on
Ethernet Version units.
RS-232 Pin Layout
1 DCD
2 RXD
3 TXD
4 DTR
5 GND
6 DSR
7 RTS
8 CTS
9 Not
Used
4.6.2 DISPLAY Port
“DISPLAY” port is used to connect to an FEC Remote Display Unit.
RS-422 Pin Layout
4.6.3 DATA-OUT (1) Port
“DATA-OUT(1)” is an output port for ASCII fastening data communication to external devices.
RS-232 Pin Layout
1 DCD
2 RXD
3 TXD
4 DTR
5 GND
6 DSR
7 RTS
8 CTS
9 Not
Used
1 TX+
2 TX-
3 RX+
4 RX-
5 GND
6 Not Used
7 Not Used
8 Not Used
9 Not Used