FEC DSP1500 Main Unit - Manual (Page 40)

enFORCE DSP1500 Main Unit Hardware Manual
(Rev. 4.0) PAGE 4 - 14
Chapter 4: Installation & Wiring
4.8.1 External I/O Disable Switch
DIP SWITCH (Factory Setting)
(Bottom View)
4.9 Firmware Flash Connector
Upgrades or revisions to firmware are handled easily with the on board Flash Connector located on
the bottom of each Main Unit. There is no need to remove or disassemble the unit. A flash adapter
(CONTROLLER-ROM) containing the new firmware can be connected to connector CN8 with the
power off to the unit. The power is then cycled on until the ACCEPT LED is blinking indicating the
firmware upload is complete. Turn off power and remove the flash adapter. The firmware update is
now complete.
Note: This connector is for FEC use only and it is not recommended for use other than FEC.
No. OFF ON
4 Not Used
3 Not Used
2 M-NET ENABLE
1 EXT. I/O ENABLE EXT. I/O DISABLE
FRONT
If Switch No.1 is turned ON, the Fieldbus Module will
be bypassed and the STOP signal will be enabled
allowing Manual operations through the front panel
buttons for testing when Fieldbus Interface is installed
and fieldbus network is not running.
When finished testing the equipment, be sure to
turn Switch No. 1 OFF otherwise the Fieldbus
Module will not operate.
Do not change Switch No. 2, 3 or 4.
Firmware Flash Connector (CN8)