FEC DSP1500 Main Unit - Manual (Page 35)

enFORCE DSP1500 Main Unit Hardware Manual
PAGE 4 - 9 (Rev. 4.0)
Chapter 4: Installation & Wiring
4.6.3.2 Output Data Format
The example below shows the format of the DATA-OUT (1) port connected to a printer. Actual
data output format may vary depending on the configuration and set-up of this port using the
DSP User Console Software. The data field is selectable from all the available output fields to as
little as one output field (See previous table for available data fields). Headers, footers & ASCII
control characters are all configurable using the DSP User Console Software.
2007/09/26 09:17:57 SEQ01 [Input Data from DATA-IN]
SP PA F LD F DS JUG Acceptable Pressing
01 01 1.50 126.042 O
2007/09/26 09:19:36 SEQ01
SP PA F LD F DS JUG Rejected Pressing
01 01 1.08L 130.001H X
2007/09/26 09:21:16 SEQ01
SP PA F LD F DS JUG Cycle Stopped
01 01 0.38L 93.540L ! (Before pressing end)
2007/09/26 09:21:34 SEQ01
SP PA F LD F DS JUG Abnormal
01 01 0.01L 0.001L A05 (Showing abnormal code)
2007/09/26 09:21:21 SEQ01
SP PA F LD F DS JUG Press Bypassed
01 00 0. 0.
Index
SEQ: Sequence
F LD: Final Load H: High
SP: Press Number F DS: Final Distance L: Low
PA: Parameter JUG: Judgment