FEC DSP1500 Main Unit - Manual (Page 92)

enFORCE DSP1500 Main Unit Hardware Manual
(Rev. 4.0) PAGE 5 - 52
Chapter 5: Control Interfaces
5.9 CC-Link
®
Interface (Version 2)
FEC integrates the CC-Link board (Version 2 setting) manufactured by HMS Fieldbus Systems AB
into the Main Unit’s modular I/O board when CC-link must send both I/O and Message Data. For
further technical information on the CC-Link (Version 2) interface go to the HMS website.
(
www.hms.se )
NOTE: The FEC CC-Link (V2) module is configured as a “Remote Device Station” when setting up
the parameters in the PLC program.
For detailed information on the Mitsubishi CC-Link Network, see the Mitsubishi User Manual #
13J872 Control & Communication - Link System Master / Local Module.
Item Description
1 Application Connector
2 CC-Link Connector
3 Baud Rate Setting Switch
4 Station Number Setting Switches (2)
5 Status LEDs (4)
6 Watchdog LED
Red - (flashing @ 2Hz) - ASIC and FLASH ROM check fault.
Green (flashing @ 2Hz) - module not initialized.
Green (flashing @ 1Hz) - module initialized and running OK.
Red (flashing @ 1Hz) - RAM check fault.
Red (flashing @ 4Hz) - DPRAM check fault.
Daughter board
3
2
5
1
6
4
HOME