Adding a frame – Teledyne LeCroy STX M6-1 SAS_SATA Protocol Analyzer User Manual User Manual
Page 118
LeCroy Corporation
Exercise and Capture
116
Sierra M6‐4 SAS/SATA Protocol Analyzer User Manual
Report expander route table list
Configure general
Enable disable zoning
Write GPIO register
Zone broadcast
Zone lock
Zone activate
zone unlock
Configure zone manager password
Configure zone phy information
Configure zone permission table
Configure route information
Phy control
Phy test function
Configure phy event
Configure Zone Permission
Adding a Frame
SAS: Click the Insert Frame button and choose the frame type to insert.
Figure 2.95: SAS: Frame Dropdown List
Note:
SSP and STP frames offer additional options.
SAS Insert Frame Command:
Identify Frame
SSP Frames (Command, Data, Task)
SMP Request Frame
STP Frames (Host to Device, DMA Setup, Data)
User Defined