Teledyne LeCroy STX M6-1 SAS_SATA Protocol Analyzer User Manual - Manual (Page 253)

Sierra M6‐4 SAS/SATA Protocol Analyzer User Manual 251
Display Configuration LeCroy Corporation
Based on Specific Command Type: You can specify a color for each command. The
software applies the setting on the Command column.
Anchor the Selection Bar
You can anchor the selection bar of the Spreadsheet View.
Set the Anchor row as sync. point: Other views synchronize based on the contents of the
anchor row.
Other
Repeat decoded command in frame column: The spreadsheet shows the name of the
command in front of all frames in the Command column. Otherwise, it will show the
name of the command only in front of the SSP command frame.
Decode CDB of Commands: The spreadsheet shows name of command in command
column, otherwise shows CDB of command in command column.
Show ‘Sector Count’ instead of ‘Xfer Length’ (SATA only): Display sector count.
Column View Tab
Figure 3.77: SAS: Software Settings Dialog Column View Tab
The SATA Software Settings dialog has the same options.